F.A.Q.

Campagnolo products maintenance info (14)

Use a 3-4 mm tip to quickly press the ON/OFF button area (below the MODE button): the LED turns on green and then flashes blue. If the controls were previously coupled with the rear derailleur, when the LED turns off this means they are coupled with the rear derailleur. When an operating lever is pressed, the led turns on blue

Use a 3-4 mm tip to press the ON/OFF button area for at least 3 seconds (below the MODE button) until the red LED turns on for 3 s

While the controls have an ON button, the rear and front derailleur do not have ON buttons and are turned on when the battery is inserted or, if the battery is already inserted, if subjected to a vibration.

No, after 30 minutes, the components go into stand-by automatically and the rear and front derailleur leds turn off

When starting to pedal, thanks to the movement sensors located in each component, all components activate and are ready to function after a few seconds

When transporting the bicycle, leave the batteries for the rear and front derailleur installed to protect the cavities and electrical contacts inside them from bad weather. Although the leds of the rear and front derailleur turn on, if the control levers are not activated, the components go into stand-by and the leds turn off after 30 minutes.

Transport it as it if were exposed to bad weather, making sure that the operating levers cannot be actuated. Otherwise, remove the rear and front derailleur batteries and turn off the controls, as they would otherwise continue to search for the rear and front derailleur and the LED would flash continuously.

No, the operation of the LEDs cannot be changed

Yes, the lever functions can be customised using the dedicated app

When connecting to the groupset with the MyCampy 3.0 app, any new firmware that is available for updating the single component is displayed

F.A.Q.

ここでは、よくある質問に対する回答を見ることができます。